How to use the Wired Remote Control device with the TVU One transmitter.

Start Live and Stop Live with one button.

Use the USB based TVU One Wired Remote Control device to trigger Start Live and Stop Live from a TVU One transmitter. The wired remote mounts to the shoulder strap of TVU One backpack.

1. Connect the wired remote to any of the TVU One USB ports.
2. Select the receiver you would like to use. Press the Go Live button to take it live from the TVU One device.
3. Press the TVU logo button on the remote to enable Start Live. The tally LED displays red.  Press the button once again to Stop Live, and the green tally LED displays green.
4. Route the USB cable through the top of the TVU One backpack and over the backpack shoulder strap.

This controller is included as standard equipment with each TVU One V3 shipment.  It is also available as an optional accessory for existing users.

NOTE: To use the TVU One Wired Remote Control with older V1/V2 units, you will need an additional patch. The patch is available by contacting TVU support at +1 (650) 440-4812 or support@tvunetworks.com

Watch our Youtube Tutorials

You can view a more in-depth video overview with our TVU One transmitter on our Youtube channel.

 

About TVU One

Visit the TVU One page to learn all the capabilities of the next level of live video transmission with the TVU One 4K. Deliver full broadcast quality 4K, 10-bit true 60fps HDR video at as low as 3Mbps with proven patented Inverse StatMux Plus technology, IS+. It’s also able to transmit live 1080p60 HDR at as low as 800Kbps.

error: Content is protected !!
This site is registered on wpml.org as a development site. Switch to a production site key to remove this banner.